Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
- 9. Brake system
9.1. Specifications
9.2. System of anti-blocking of brakes (ABS)
9.3. Brake shoes of forward brakes
9.4. Support of forward brakes
9.5. Brake shoes of back disk brakes
9.6. Support of back disk brakes
9.7. Brake disk
9.8. Brake shoes of back drum-type brakes
9.9. Working cylinder
9.10. Main cylinder of brake system
9.11. Brake hoses and tubes
9.12. Hydraulic system of brakes
9.13. Vacuum amplifier
9.14. Hand brake
9.15. Ropes of the hand brake
9.16. Brake pedal
9.17. Switch of headlights of a stoplight
9.18. The valve of restriction of the pressure, sensitive to car loading
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment
|
Prevention
If it is necessary to carry out a partition of the working cylinder (usually because of leakage of brake liquid) previously learn the price of spare parts or cost of already vosstavlenny or new cylinder. Before the beginning of a partition get a repair set. Always repair both workers of the cylinder together, – never repair only one of them.
Removal
| PERFORMANCE ORDER |
| 1. Lift a back part of the car and establish it on support. Block lobbies a wheel that the car casually did not sweep. |
| 2. Remove brake shoes of a back brake (see subsection 9.8). |
| 3. Remove dirt round the working cylinder. |
|
4. Disconnect a brake tube (1) by means of a cap wrench if is available. Do not lift the receiver from the cylinder. Turn off fixing bolts (2) workers of the cylinder. |
| 5. Remove the working cylinder from a board of a back brake and establish it on a pure desktop. As soon as possible close an opening of a brake tube for prevention of loss of brake liquid and hit in a dirt tube. |
|
Partition
| PERFORMANCE ORDER |
| 1. Remove the valve of production of air, caps, pistons, covers and springs from the cylinder (see fig. Elements of a back drum-type brake). |
| 2. Wash out the working cylinder brake liquid, alcohol or cleaning liquid for the mechanism of brakes. |
Prevention
It is forbidden to use solvents on the basis of gasoline for cleaning of elements of brakes.
|
| 3. By means of the clean compressed air dry up the working cylinder and blow channels. |
| 4. Check an internal surface of the cylinder on existence of corrosion and scratches – it is necessary to replace the cylinder, if its internal surface is scratched or has corrosion traces. |
| 5. Grease new caps with brake liquid. |
| 6. Collect elements of the working cylinder. Check, that cap edges inspectors inside. |
|
Installation
| PERFORMANCE ORDER |
| 1. Establish the working cylinder on a place and fingers twirl fixing bolts. Connect a brake tube to the working cylinder. Check reliability of connection. Tighten bolts of fastening of the working cylinder till the demanded moment of an inhaling specified in the section of technical characteristics at the beginning of this chapter. |
| 2. Reliably tighten connection of a brake tube and establish brake shoes (see subsection 9.8). |
| 3. Pump over brake system (see subsection 9.12). |
| 4. Check work of brakes before the beginning of normal operation of the car. |
|
|
|