Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
- 12. Electric equipment
12.1. Safety locks
12.2. Burned-through crossing points
12.3. Automatic switches
12.4. Relay
12.5. Breakers of indexes of turns / alarm system
12.6. The combined switch
12.7. The switches established on a steering column
12.8. Lock of ignition and lock drum
12.9. Switch of a heater of back glass
12.10. Heater of back glass
12.11. Radio receiver and loudspeakers
12.12. Aerial
12.13. Bulbs of headlights of head light
12.14. Headlights of head light
12.15. Replacement of bulbs
12.16. System of day inclusion of headlights
12.17. Engine of screen wipers
12.18. Instrument guard
12.19. Sound signal
12.20. System cruise control
12.21. System of the central lock
12.22. System of window regulators
12.23. Rear-view mirrors with the electric drive
12.24. Safety airbag
+ 12.25. Electroschemes
|
Prevention
On these models the airbag of safety which can reveal is established (it will be filled with air) when it is connected to the accumulator. Disconnect a wire of the negative plug of the accumulator and wait for at least two minutes before the work beginning with a safety airbag.
If the stereoplayer of your car has coding system, check, whether you know a code of activation of a player before an accumulator detachment.
IGNITION LOCK
Removal
Table of connection of a tester and conductivity of the lock of ignition
Check and replacement
| PERFORMANCE ORDER |
| 1. Check wires from the ignition lock to the socket of connection and disconnect it. |
| 2. By means of an ohmmeter check conductivity of an electric current between the specified plugs when a key in the lock of ignition will turn in various provisions. |
| 3. Replace the ignition lock, if conductivity between contacts of the socket of connection not such as it is specified in the table. |
| 4. Turn off the screws, ignitions fixing the lock to the case of a drum of the lock and remove the ignition lock. |
| 5. Installation is carried out upside-down removals. Being guided by instructions, (see subsection 10.16) adjust a wire twirled by a spiral, before installation of a steering wheel. |
|
DRUM OF THE LOCK OF IGNITION
Check and replacement
| PERFORMANCE ORDER |
|
1. When the key is in the provision of giving of a food on car electric equipment (situation ASS), insert a small screw-driver or a spoke into a case opening, press on disconnecting button and get a drum. Remove it from a steering column. |
| 2. Installation is carried out upside-down removals. Being guided by instructions, (see subsection 10.16) adjust a wire twirled by a spiral, before installation of a steering wheel. |
|
|
|