Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
- 7. Transmissions
+ 7.1. Mechanical transmission
- 7.2. Automatic transmission
7.2.1. Specifications
7.2.2. Diagnostics
7.2.3. Replacement of epiploons
7.2.4. Butterfly valve rope
7.2.5. A being switched rope
7.2.6. The switch blocking inclusion of a starter by included transfer
7.2.7. Transmission fastening
7.2.8. Removal and transmission installation
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment
|
Leakage of oil often happens because of wear of epiploons of axes and / or wear of an epiploon and sealing rings of a drive of a speedometer. Replacement of these epiploons is rather simple, as it can be carried out, without removing a transmission from the car.
Epiploons of semi-axes
Epiploons of semi-axes are located on each side transmissions where shlitsa of the internal ends of semi-axes enter in a shlitsa of gear wheels of differential. If you suspect that the epiploon of a semi-axis proceeds, lift the car and establish it on support. If the epiploon proceeds, you will see an oil strip sideways transmissions, under an epiploon.
| PERFORMANCE ORDER |
| 1. Remove a semi-axis (cм. subsection 8.3). |
|
|
2. By means of a screw-driver accurately get an epiploon from a transmission nest. Try not to damage a nest of installation of the epiploon, differently a new epiploon will proceed. |
| 3. If the epiploon cannot be removed by means of a screw-driver, it is necessary to use the special tool for removal of epiploons (it is possible to get on a car market or in autoshop). |
|
4. Using the tool for installation of epiploons or a piece of a pipe of big diameter as an opravka, establish a new epiploon. Accurately establish it in a nest and check, that it was densely and is up to the end established. |
| 5. On transmission А132L completely established epiploon should be flush with a surface of a case of a transmission; on the A240L model completely established epiploon of the left semi-axis should be lower on 5,16 mm than a case surface, and an epiploon of the right semi-axis – on 3,175 mm. |
| 6. Grease edges of a new epiploon with multipurpose greasing, and then establish a semi-axis (cм. subsection 8.3). Try not to scratch edges of a new epiploon. |
|
Sealing ring of the sensor of speed
The sensor of speed is located on a transmission case.
| PERFORMANCE ORDER |
| 1. Examine area round the sensor on existence потеков oils to define, whether the sealing ring proceeds. |
|
|
2. Disconnect the socket of connection of the sensor of speed (it is specified by an arrow), turn off a bolt (is specified by an arrow) and pull out the sensor from a transmission. |
| |
3. By means of a small screw-driver remove a sealing ring from the sensor and establish a new sealing ring. Try not to scratch a surface of the sensor or a flute of a sealing ring. Grease a new sealing ring with liquid of an automatic transmission for its protection at sensor installation. |
| 4. Installation is carried out upside-down removals. |
|
|
|